Our NJ warehouse is back open so all orders will be sent same day as usual
We have a core crew working in isolated shifts to process orders from both of our warehouses
All phone lines and email channels are open as per usual
Can't find what you're looking for?Get in touch!
Unsure? Our returns policy is excellent!
The Ninja V4 LED glow poi are the best thing to come from New Zealand's HomeofPoi yet!
Perfect for performance, with 7 colours and 64 modes and patterns, these will never get old, and the included rechargeable batteries will help make sure of that.
High quality ball bearing swivels at the handle attached to the 8mm soft colecord, mean that you can spin as fast as your hands will go. The rubber rings around the casing add both weight and protection to the poi heads, meaning you won't need to add anything to these beauties.
The updated V4 Ninja Poi have these new features:
- All small components are also glued onto the circuit board for extra durability.- Extra 20 modes plus a "demo" mode which scrolls through a selection of the custom patterns.- Memory function, restarts at the last setting it was on when turned off or battery dies.- New comfort 8mm Colecord and attachment system.- New, more reliable and durable electrics.- Thicker reinforced base.- Rechargeable AA Battery NI-MH 2400mAh included.
Check them out in action here:
The cords on these glow poi are adjustable from 52cm to 80cm (20" - 31")
How to Adjust the length of your Colecords
Near the swivel pull the excess Colecord through the small circular ring to find your perfect spinning length. Then mark the place where you will cut the Colecord next to the small ring on the excess cord. Lengthen the excess Colecord to clearly show the mark then cut on the marked point.
Melt the end of the Colecord with a lighter to prevent further fraying, a small circular dish of melted Colecord will suffice.
Practicing the melting process can also be done on the excess off-cut of Colecord before trying on your actual cords.
Once the melted disk has cooled and hardened pull the Colecord tight to the desired length again so that the small melted dish sits tightly next to the ring.
A small stopper knot can be tied in the excess colecord for a less permanent way to adjust the length, if your poi are to be used by more than one spinner.
We promise not to spam you!